Rothenberger 80000 Monoblock Tap Spanner Set

Product Information

Before actually removing or replacing any part of your water system it’s advisable to first turn the water off and drain down the system if you can. The nut sizes vary on different taps, so a monobloc tap spanner set between 8 – 13mm will do the job. Tools you’ll find useful for this task are a flathead screwdriver, a tap spanner, an adjustable spanner and a pair of grips. Pull-out Spray Mixer. With an extendable hose, this tap is perfect for rinsing dishes and food and can be used to control the flow of the water.

Open the kitchen tap to let the water out, and open a tap upstairs if you have one. This will release most of the water lying in the pipes. Water filter taps. With an in-built water filter, these taps help to filter out excess chlorine and impurities from the water making them ideal as part of a kitchen sink. Learning how to change bath taps is quite a bit different and can be a lot harder! How to Change a Kitchen Tap How to Remove a Kitchen Tap To make the process as easy as possible for you, we’ve collated all the relevant information you’ll need. See the headings below! Plumbing in a new mixer tap is a fairly simple job and should take between 30 minutes to an hour to install depending on the level of experience of the person installing it. If at any point of the installation you are unsure or require help it is recommended to have a professional plumber on hand that you can call for advice.

We will be happy to serve you

Though fitting a full bathroom suite is a job you’ll want to get a professional in to do, if you’ve got a bit of DIY and plumbing experience, then fitting a mixer tap to the basin in your bathroom is a job you can do relatively easily.

Once the tap has been dropped through the hole and the flat washer or mounting plate place over the threaded bars, it is time to slide the steel washer in place. Remove your old tap by undoing the connection by using your grips and a spanner. If you have a a spanner then use this to hold the tap in place while you unscrew the nut holding the tap in place. Put the old tap to one side to be disposed of. Make sure you turn the water supply off first and make sure to tighten the nuts up securely as you don’t want the tap coming loose after a few uses. Hoses are pre-fitted to mixer taps. If not, screw the hoses into the tap base carefully, tightening by hand only. Follow the instructions which come with the tap. Feed the mains connection ends through the location hole - be careful with the sharp edges on stainless steel sinks and make sure any seals, gaskets, washers and studs are pre-fitted and located according the instruction’s steps.If your caravan or motorhome mixer tap has become loose or started leaking then chances are you’ll probably need to replace it. Depending on the make, model and age of your leisure vehicle, replacing this tap could be straightforward or a little more time consuming. In most cases you can either find advice from your manufacturer, parts supplier or online via the wealth of information that has been shared by other caravan or motorhome owners. If you’ve come across this blog then we’ll do our best to share some basic guidance on how to replace a caravan mixer tap and point you towards the mixer tap spares we offer to help you get the job done. How to remove a caravan mixer tap